If you have any notion about running multiple machines at once with the UNCNC, you will need both the controller and licence for each machine. Note that you can move the laptop with the interface to another CNC. So the bottom line, its going to cost you $170 for each UC100 (or other UC device) you want to use with the UCCNC software.Īll that said the UCCNC and UC100 combo is still a good deal as long as you are only going to use a single computer to control a single CNC machine. The licence key is tied to the serial number of one of the above motion controllers which means for each controller you purchase, you will also have to purchase a separate licence key. UC400ETH - Ethernet based controller with 2 IDC connectors UC300ETH - Ethernet based controller with 6 IDC connectors UC300 - USB based controller with multiple 6 IDC connectors (Discontinued) UC100 - USB based controller with a LPT compatible interface. It is fully functional, but can not talk to your machine until its licenced.Ī licence costs $60 and will only talk to one of the following motion controllers. The software is free to down load and runs in demo mode. It uses Visual C# as it macro languages and is fully modifiable. It supports both the 32bit and 64bit versions of the software. The software runs on and is fully functional on: The UCCNC is CNC controller software that works their own USB and Ethernet motion controllers.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |